| Welcome Guest, Log in or Register |
| Author | [Modern View] |
TimD
|
I bought and have used the 1120 for about 10 years. Always ran quiet until now. It is quiet when in the hay but there is a hammering noise and vibration that is sent down the driveline back to tractor causing the PTO in the tractor to rattle or hammer. New UV joints on all driveline shafts, front shaft is 2 years old with CV joint. There is a little slack in the slip tube on upper PTO shaft that runs gear box but very little, and very little backlash in the gearbox. All of the sickle drive seems to be tight and the rollers are timed with proper clearance. Put old PTO hookup shaft on and it does the same thing. Should not be the tractor as it is the same tracor I run square baler with and it runs quiet. Any help will be greatly appreciated. THANKS |
|
08-13-2010 09:25:43
| | Re: Hesston 1120 mower conditioner hammer in reply to TimD, 07-05-2010 09:38:33 |
I have mine torn down awaiting parts now. The bearings were dry and the sleeve inserts were worn on the eccentric arm. Lots of clatter, then wire grass snapped the head off the cutter bar and the pitman/flywheel broke as a result. A new flywheel is almost nonexistant and over $600 if it can be found, my dealer could only find one in the whole USA. Fix yours before this happens to you. |
[Log in to Reply][No Email] |
|
|
| TRACTOR PARTS | TRACTOR MANUALS |
|---|
| We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ] |
Home | Forums
Today's Featured Article - Pop's Tractor of Gold -
by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre 'spread'. Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello, ...
Hesston 1120 Haybine Manual Diagram
[Read Article]
Hesston 1120 Haybine Manual For Sale
Latest Ad: Forklift forks that will fit Caterpillar 50. Groove height is 16 Either 36 or 42 long and 4-5 wide. Looking in northern half of Ohio. [More Ads]
Copyright © 1997-2021 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy PolicyTRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
